• Design & Built as per customer         requirement.
  • High quality switch gears & automation         components.
  • Fabrication with CRCA Steel Sheet.
  • Degree of Protection: IP42, IP55, IP65.
  • High Quality Powder Coated Paint         (Seven Tank Process)
  • Maintenance friendly assembly
  • Neat and Methodical Wiring

    Capacitor Panels improve the power factor by adding capacitive reactance in steps as per the power factor requirement.Power factor controller constantly monitors the load (and power factor) of the system on LV Panel and switch on/ off the capacitor steps to maintain the system power factor to the set value. It provides optimum power factor improvement to compensate for lagging Vars in the system, seen as a clean and reliable solution to providing quality power to the distribution network and to economize the electricity charge to customer/consumer.

    Basically it is measured in KVAR ( Kilo Volt Ampere Resistance)

  • type tested assemblies for busbars
  • Rated upto 15 KVAR to 2000 KVAR
  • Power factor correction by multi step design , or in stages
  • Standard & detuned capacitor banks
  • Capacitors are Self healing, pressure sensitive disconnector & fitted with discharge         resistors
  • Detuned reactor tuning order
  • Microprocessor based power factor controller with various switching sequences
  • Special contactors for power factor correction capacitors; equipped with limiting         resistance for the inrush current.
  • Easy installation & maintenance